I received some quick disconnects for my fuel lines. I intended to place them above and below my fuel filters to make them easier to replace. Unfortunately, the quick connects are too large to fit where I wanted them to.
I re-routed the fuel lines around the fuel flow sensor to alleviate the rubbing issue the fuel line was have with the oil tank bracket. I also added a wire clamp to hold the fuel flow sensor in place. The directions for the fuel flow sensor suggest that you route the sensor on it's side with a slight amount of angle. This give the internal spindle the least amount of friction since it is only resting on one bearing but allows air bubble to escape. My mounting has a little more angle than they specified but it does accommodate my fuel line routing.
